DRAW: RECTANGLE BETWEEN SELECTED LINES
RECL command draws a rectangle (or quadrilateral) between two selected lines or polyline segments. It allows you to close custom shaped holes easily.
DRAW: RECTANGLE WITH SPECIFIED AREA
RECA command allows you to draw rectangle with specified area. APLUS will ask for start point and then give you live preview of the rectangle.
ARCHITECTURAL: DRAW RAMP
APLUS can help you design a ramp for underground parking. APLUS decides where to break ramp to make it usable.
POLYLINES: DRAW PART OF POLYLINE CONTAINED INSIDE OTHER ONE
APLUS can draw part of polyline which lays inside another polyline.
POLYLINES: DRAW CEILING HOLE SYMBOL FROM SELECTED POLYLINE NEW!
With PLHO command you can draw ceiling hole symbol from selected polyline. APLUS will create new, closed polyline.
HATCHES: TURN OFF OR ON ALL HATCHES!
With HOFF and HON commands you may easily control visibility of hatches inside your drawings. This command turns off or on all hatches regardless of their layer.
HATCHES: UNION HATCHES NEW!
APLUS can union selected hatches. APLUS will set style of first selected hatch to other selected hatches.
HATCHES: DRAW HATCH BOUNDARY !
HBO command can draw boundary of selected hatch pattern. This may help you recover some lost information from a drawing.
PLUMBING: DRAW DUCTS!
After setting some parameters you may easily design ducts both inside and outside buildings.
DIMENSIONS: DIMENSION LINES SHIFT!
APLUS can detect dimension lines adjacent to one that was selected and then move them to a new position.
DRAW: DRAW DETAIL RECTANGLE!
DETAIL2 command works similar to DETAIL command, but it uses rectangular window shape instead of circular in DETAIL.
DRAW: NEW GRASS GENERATOR NEW!
With APLUS you can now easily create grass. You only have to specify height and draw path for ground. New grass pattern generates polylines instead of lines.
POLYLINES: MOVE, ROTATE OR SCALE MULTIPLE POLYLINE SEGMENTS
PLM command allows you to move multiple polyline segments at once. PLRO rotates polyline segments and PLSC scales them. With these commands you may modify polylines freely.
ATTRIBUTES: CHANGE CASE OF ATTRIBUTES
ATTCASE commmand can change case of selected attributes. This command can change case of attributes in selected instances of a block.
BLOCKS: REMOVE ELEMENT FROM BLOCK DEFINITION
With BREMOVE command you may remove selected objects from block definition. Duplicate of removed objects will appear in the same place. Objects are removed from all instances of the block.
BLOCKS: EXPLODE ALL BLOCKS
Command BXA will find and explode all blocks in your drawing. Additionally - block definitions will also be removed.
TOOLS: DRAW TABLE BORDERS FOR TEXT OBJECTS
APLUS is able to draw table borders for selected TEXT or MTEXT objects. TABL command
128 MB of RAM (minimum)
50 MB of hard disk space (minimum)
128 MB of disk swap space (minimum)
50 MB of free disk space in your system folder
Intel Pentium III 500 MHz, or compatible processor
Network Interface Card (for network installation only)